Installing The M.2 2230 Solid-State Drive - Dell Vostro 3405 Service Manual

Installing the M.2 2230 solid-state drive

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2230 solid-state drive.
NOTE: The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on
the M.2 card slot:
● M.2 2230 solid-state drive + 2230 mounting bracket
● M.2 2280 solid-state drive
The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Place the solid-state drive into the thermal plate and install the single (M2x2) screw.
2. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
3. Slide the M.2 2230 solid-state drive into the M.2 card slot on the system board.
4. Replace the single (M2x2.2) screw and tighten the single captive screw to secures the thermal plate to the palmrest.
Next steps
1. Reconnect the battery.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in
24 Disassembly and reassembly
After working inside your computer.