Steps
1. Using the alignment posts, place the power-button into its slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2) that secure the power-button to the palm-rest and keyboard assembly.
3. Connect the power-button cable to the fingerprint-reader board and close the latch, if applicable.
4. Adhere the tape that secures the power-button cable to the palm-rest and keyboard assembly, if applicable.
Next steps
1. Install the
IO
board.
2. Install the battery.
3. Install the
base
cover.
4. Install the
SD
card.
5. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the battery.
5. Remove the
wireless
card.
About this task
The following images indicate the location of the display assembly and provides a visual representation of the removal
procedure.
44
Disassembly and reassembly
After working inside your
Before working inside your
computer.
computer.