Parameter assignment
6.1 Setting elements on the 3RW51 soft starter
⑦
⑧
⑨
Requirements
• Flat-bladed screwdriver or cross-tip screwdriver PZ1
Procedure
• Insert the flat-bladed screwdriver in the opening of the setting element.
• Turn the flat-bladed screwdriver until the arrow of the setting element points to the required
parameter setting.
Tip
The displays on the setting elements are approximate values subject to manufacturing
tolerances. To make detailed settings, use a 3RW5 HMI (accessory).
72
MODE key
•
Parameterization of RESET MODE
•
Deactivation / Activation of Soft Torque
•
Parameterization of ON / RUN relay output
•
Parameterization of the response to bus errors
•
Restoring factory setting
Scale of rated operational current I
You will also find the applicable scale in the Technical data (Page 161).
RESET / TEST key
•
Acknowledges faults
•
Performs the user test
•
Parameterization of ON / RUN relay output
•
Parameterization of the response to bus errors
•
Restoring factory setting
of the motor
e
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003
SIRIUS 3RW51 Soft Starter