3Rw5 Hmi Standard Menu - Siemens SIRIUS 3RW51 Equipment Manual

Functions
8.11 3RW5 HMI Standard
Key
8.11.2

3RW5 HMI Standard menu

The following information is shown on the display of the Standard HMI module:
• Operating state
• Measured values
• Parameters
While you are setting the parameters, the actual value is shown in the display.
• Diagnostics
Operating state
Display Explanation
ON
STATE
RAMP
STATE
OFF
STATE
ER O
STATE
WN I
OVLD
WN O
OVLD
ER O
OVLD
----
OVLD
106
Actions
• Changes master control
LOCL means that the 3RW5 HMI Standard is the master control.
REMT means that the 3RW5 HMI Standard is not the master control.
• Locking switch Locked / Unlocked:
To be able to operate the 3RW51 soft starter with the 3RW5 HMI Standard, the locking switch
on the rear of the 3RW5 HMI Standard must be unlocked. If the locking switch on the rear
of the 3RW5 HMI Standard is in the "Locked" switch position, the "RESET / TEST", "LOCL /
REMT" and "Start" and "Stop" keys are disabled. Navigation through the menu using the
navigation keys, however, is still possible.
The ramp-up time comes to an end and the motor is running.
The ramp-up time or the stopping time is active.
The motor is switched off.
The motor is not ready to start because there is a fault.
Additional information is provided by the diagnostics display.
The motor is switched on. A motor overload protection warning is pending.
The motor is switched off. A motor overload protection warning is pending.
The motor is switched off. There is a fault at the motor overload protection.
No motor overload exists.
STATE
OVLD (OVERLOAD)
OVLD% (OVERLOAD in percent)
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003
SIRIUS 3RW51 Soft Starter