Mazda CX-9 2021 Manual page 118

Before Driving
Doors and Locks
Function
number
When the ignition is switched ON
and the selector lever is shifted from
park (P) to any other gear position, all
the doors and the liftgate lock auto‐
5 matically.
When the selector lever is shifted to
park (P) while the ignition is switched
ON, all the doors and the liftgate un‐
lock automatically.
All the doors and the liftgate lock au‐
tomatically when the vehicle speed is
about 20 km/h (12 mph) or more.
6 When the selector lever is shifted to
park (P) while the ignition is switched
ON, all the doors and the liftgate un‐
lock automatically.
*
1 Other settings for the auto door lock function are
available at an Authorized Mazda Dealer. For
details consult an Authorized Mazda Dealer.
Refer to the Settings section in the Mazda
Connect Owner's Manual.
Settings can be changed using the
following procedure.
1. Safely park the vehicle. All doors and
the liftgate must remain closed.
2. Switch the ignition ON.
3. Press and hold the lock side of the
driver's door-lock switch within 20
seconds of switching the ignition ON,
and make sure a beep sound is heard
about eight seconds afterwards.
4. Refer to the auto lock/unlock function
setting table, determine the function
number for the desired setting. Press
the unlock side of the driver's
door-lock switch the same number of
times as the selected function number
(Ex. If you select function 2, press the
unlock side of the switch only 2 times).
5. Three seconds after the function
setting has been changed, a beep sound
will beep in the amount of the selected
3-18
*1
Function
function number. (Ex. Function
number 3 = 3 beep sounds)
Current Function Number
Press unlock side of
lock switch once
Function Number 1
Press 2 times
Function Number 2
Press 3 times
Function Number 3
Press 4 times
Function Number 4
Press 5 times
Function Number 5
Press 6 times
Function Number 6
Press 7 times
Cancel setting
NOTE
The doors and the liftgate cannot be

locked or unlocked while the setting
function is being performed.
The procedure can be cancelled by

pressing the lock side of the driver's
door-lock switch.
▼ Locking, Unlocking with Door-Lock
Knob
Operation from inside
To lock any door from the inside, press the
door-lock knob.
To unlock, pull it outward.
Press lock side of
lock switch
Cancel setting
Wait for 3 second
Function set (The
number of beeps
heard is the same as
the selected function
number)