Developing Internal Timing Sense (Quiet Count); Playing Along With A Changing Tempo (Auto Up/Down) - Roland TD-07 Owner's Manual

Developing Internal Timing Sense
(QUIET COUNT)
This practice will help you develop a good sense of time/
tempo. The metronome alternates between "sounding and
not sounding" at every specified length, and the cycle will
repeat.
1
In the QUIET COUNT screen, press the [ ]
(ENTER) button.
MEMO
If you decide to stop mid-way through practice, press the
[ ] (EXIT) button.
2
Strike the pad in time with the metronome.
The metronome will sound during the first few measures.
When you reach the last measure during which the
metronome will sound, the screen will indicate "Ready.. "
Ì=120
Ready..
When the metronome stops sounding, the screen
indication will change to "QUIET!!" Continue striking the
pads during this time.
Ì=120
The strike timing is evaluated following the QUIET
interval.
Ì=120
SCORE:100
3
Press the [ ] (EXIT) button to finish.
QUIET COUNT settings
You can specify the number of measures in which the
metronome will sound and the number of measures in
which it will not sound.
1
In the QUIET COUNT screen, use the [C][A]
buttons to select the item (parameter) that you
want to set.
2
Use the dial to change the value.
Parameter Value
2, 4, 8, 16
Measures
(measures)
1-3
4-*
1-2
Explanation
Specify the length (measures) of the
interval for which the metronome
will alternate between "Sounding"
and "Quiet. "
Practicing in Coach Mode (COACH)
Parameter Value
Of the measures specified by "Measures, " this
setting specifies the length of the measures that
will be "Quiet"
RANDOM
Quiet
1, 2, 4
20–260
Tempo
(bpm)
3
Press the [ ] (DRUM KIT) button to return to
the DRUM KIT screen.
Playing Along with a Changing Tempo
(AUTO UP/DOWN)
The metronome increases and decreases tempo over time,
to help develop stamina and endurance. The tempo will
increase in steps for each beat until the metronome reaches
the upper limit; then the tempo will continue slowing down
in steps until it reaches the initial tempo. This cycle will
repeat.
1
In the AUTO UP/DOWN screen, press the [ ]
(ENTER) button.
A two-measure count-in is played when you start.
MEMO
If you decide to stop mid-way through practice, press the
[ ] (EXIT) button.
2
Strike the pad in time with the metronome.
The remaining time is shown in the lower right of the
screen.
Ì=121
ÃMAX260
* Auto Up/Down does not let you change the current
tempo.
* The current tempo value will be the lower tempo limit.
This ends when the specified time has elapsed, and the
strike timing is evaluated.
Finished! [EXIT]
SCORE:100
3
Press the [ ] (EXIT) button to finish.
Explanation
The length of the QUIET interval will
randomly change each time.
Specifies the length (number of
measures) of the QUIET interval.
* This setting cannot be longer
than half of the Measures value.
Sets the tempo.
1-4
3
9