Midi Settings; Making System Settings - Roland TD-07 Owner's Manual

Making Detailed Settings (SETUP)

MIDI Settings

Here's how to make MIDI-related settings for the TD-07.
1
Press the [ ] (SETUP) button.
2
Use the [C][A] buttons to select "MIDI," and
press [ ] (ENTER) button.
3
Use the [C] [A] buttons to select the item
(parameter) that you want to edit, and use the
dial to change the value.
Parameter Value
Channel 1–16Ch
Tx/Rx Sw OFF, ON
ProgChg Tx OFF, ON
ProgChg Rx OFF, ON
Local Ctrl OFF, ON
Choke Shot
OFF, ON
Device ID
17–32
SysEx Tx OFF, ON
SysEx Rx OFF, ON
4
Press the [ ] (DRUM KIT) button to return to
the DRUM KIT screen.
24
Explanation
Transmit and receive channel.
Turns the transmitting and
receiving MIDI messages on/off.
Turns program change
transmission on/off
Turns program change reception
on/off
Turns on/off the connection
between the performance data
from the pads and the TD-07's
sound generator section
Normally you'll leave this "ON. "
If this is "OFF, " the performance
data from the pads is not
connected to the TD-07's sound
generator section.
Specifies operation when you
strike a pad while choking it.
If this is "ON, " striking a pad while
choking it causes it to be muted
immediately after sounding. If
this is "OFF, " immediate muting
does not occur even if you strike
a pad while choking it.
Device ID setting
The setting described here is
necessary only when you wish
to transmit separate data to two
or more TD-07 units at the same
time. Do not change this setting
in any other case.
Specifies whether changes to the
TD-07's settings are transmitted
as system exclusive messages
(ON) or not transmitted (OFF).
Specifies whether system
exclusive messages are received
(ON) or not received (OFF).

Making System Settings

Here's how to make settings for the TD-07's power supply,
volume, display, and USB COMPUTER port input/output.
1
Press the [ ] (SETUP) button.
2
Use the [C][A] buttons to select "SYSTEM,"
and press [ ] (ENTER) button.
3
Use the [C] [A] buttons to select the item
(parameter) that you want to edit, and use the
dial to change the value.
Parameter Value
LCDContrast 1–16
USB In
-36–+12dB
USB Out -24–+24dB
GENERIC,
USBDrv
VENDOR
Earplugs OFF, ON
OFF, 10MINS,
AutoOff 30MINS,
4HOURS
4
Press the [ ] (DRUM KIT) button to return to
the DRUM KIT screen.
Explanation
Adjusts the brightness of the
display.
Adjusts the input level of the
USB audio that is input via the
USB COMPUTER port.
Adjusts the output level of the
USB audio that is output via the
USB COMPUTER port.
Changes the USB driver mode.
Specify "GENERIC" if you want to
use the generic driver provided
by the operating system, or
"VENDOR" if you want to use
the TD-07's dedicated driver
provided by Roland.
* If you change this setting, it
takes effect when the TD-07's
power is turned off and on
again.
If this is "ON, " the volume of your
drum performance is decreased.
If you want to protect your
hearing from high volume, such
as when children are using the
TD-07, we recommend that you
turn this "ON. "
Turns the power off
automatically when no pad has
been struck and no operation
performed within the specified
time (10 minutes, 30 minutes, 4
hours).
If this is "OFF, " the power does
not turn off automatically.