2.
Disconnect the harness from the connector (CN1) on the CN-3425 board.
Harness
CN1
3.
Install the removed parts by reversing the steps of removal.
4-11-3.
PROMPTER/GENLOCK/TEST OUT Connector (CN-3428 Board)
Preparation
1.
Remove the MIC panel assembly. (Refer
Procedure
1.
Remove the three screws, and detach the two BNC caps and the PROMPTER/GENLOCK/TEST OUT connector
(CN-3428 board).
2.
Disconnect the harness from the connector (CN3) on the PROMPTER/GENLOCK/TEST OUT connector
(CN-3428 board).
CN3
PROMPTER/GENLOCK/TEST OUT connector
(CN-3428 board)
3.
Install the removed parts by reversing the steps of removal.
4-11-4.
REMOTE Connector (CN-3430 Board)
Preparation
1.
Remove the MIC panel assembly. (Refer
HDC4300
AUDIO IN connector (CN-3425 board)
to"4-11-1. CN-3429 Board/CN-3427 Board" on page 4-47
to"4-11-1. CN-3429 Board/CN-3427 Board" on page 4-47
Rear view
B2.6 x 5
Rear view
B2 x 5
)
BNC cap
B2 x 5
)
4-50