Table of Contents
Advertisement
4-7-3.
SW-1525 Board
Preparation
1.
Remove the front assembly. (Refer
2.
Remove the handle assembly. (Refer
Procedure
1.
Disconnect the harness from the connector (CN2) on the SW-1525 board.
2.
Remove the screw, and detach the SW-1525 bracket.
3.
Remove the two screws, and detach the SW-1525 board.
SW-1525 bracket
Harness
Note
When installing the SW-1525 board to the SW-1525 bracket, match the boss with the slit. When installing the
SW-1525 bracket to the main unit, match the two bosses with the two holes.
4.
Install the removed parts by reversing the steps of removal.
HDC4300
to"4-5. Front Assembly" on page 4-17
to"4-7-2. VF Connector (CN-3422
PSW2 x 5
Holes
Boss
Bosses
)
Board)")
CN2
SW-1525 board
PSW2 x 5
Slit
4-25
Advertisement
Table of Contents
