Table of Contents
Advertisement
4-10.
DC Fan (Rear)
Preparation
1.
Remove the outside panel assembly. (Refer
Procedure
1.
Disconnect the harness from the connector (CN107) on the DPR-370 board, and detach the DC fan (rear).
DC fan (rear) assembly
Note
• When installing the DC fan (rear), pay attention that the fan duct is not over the plate.
• When installing the DC fan (rear), be careful not to deform the air vent of the fan duct.
2.
Remove the DC fan (rear) from the fan duct.
Fan duct
Note
When installing the DC fan (rear), carefully install it paying attention to the label and harness locations.
3.
Install the removed parts by reversing the steps of removal.
HDC4300
to"4-3-1. Outside Panel
Plate
Harness
DC fan (rear)
Label
Harness
Assembly")
CN107
DPR-370 board
4-46
Advertisement
Table of Contents
