Table of Contents
Advertisement
4-9.
DC Fan (Front)
Preparation
1.
Remove the inside panel assembly. (Refer
2.
Remove the outside panel assembly. (Refer
3.
Remove the front assembly. (Refer
Procedure
1.
Release the harness from the clamper.
2.
Disconnect the harness from the connector (CN3) on the MB-1214 board.
3.
Open the OHB sliding sheet as shown in the figure.
Note
The OHB sliding sheet is attached to the SUB frame. When removing it, be careful not to damage the SUB frame.
4.
Remove the DC fan (front) assembly.
DC fan (front) assembly
HDC4300
to"4-2. Inside Panel
to"4-3-1. Outside Panel
to"4-5. Front
Assembly")
OHB sliding sheet
SUB frame
Assembly")
Assembly")
Harness
Clamper
CN3
MB-1214 board
4-44
Advertisement
Table of Contents
