Arp Inspection Log Status; Figure 106 Arp Inspection Vlan Status; Table 72 Arp Inspection Vlan Status - ZyXEL Communications GS-3012F/3012 User Manual

Figure 106 ARP Inspection VLAN Status

The following table describes the labels in this screen.

Table 72 ARP Inspection VLAN Status

LABEL
Show VLAN range
Enabled VLAN
Selected VLAN
Apply
VID
Received
Request
Reply
Forwarded
Dropped

23.6.2 ARP Inspection Log Status

Use this screen to look at log messages that were generated by ARP packets and that have not
been sent to the syslog server yet. To open this screen, click Advanced Application > IP
Source Guard > ARP Inspection > Log Status.
GS-3012/GS-3012F User's Guide
DESCRIPTION
Use this section to specify the VLANs you want to look at in the section
below.
Select this to look at all the VLANs on which ARP inspection is enabled in
the section below.
Select this to look at all the VLANs in a specific range in the section below.
Then, enter the lowest VLAN ID (Start VID) and the highest VLAN ID (End
VID) you want to look at.
Click this to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above.
This field displays the total number of ARP packets received from the
VLAN since the Switch last restarted.
This field displays the total number of ARP Request packets received from
the VLAN since the Switch last restarted.
This field displays the total number of ARP Reply packets received from
the VLAN since the Switch last restarted.
This field displays the total number of ARP packets the Switch forwarded
for the VLAN since the Switch last restarted.
This field displays the total number of ARP packets the Switch discarded
for the VLAN since the Switch last restarted.
Chapter 23 IP Source Guard
197