Figure 10 Transceiver Installation Example; Figure 11 Connecting The Fiber Optic Cables; Figure 12 Removing The Fiber Optic Cables; Figure 13 Opening The Transceiver's Latch Example - ZyXEL Communications GS-3012F/3012 User Manual

Chapter 3 Hardware Overview
3.1.3.1 Transceiver Installation
Use the following steps to install a mini-GBIC transceiver (SFP module).
1 Insert the transceiver into the slot with the exposed section of PCB board facing down.
2 Press the transceiver firmly until it clicks into place.
3 The Switch automatically detects the installed transceiver. Check the LEDs to verify that
it is functioning properly.
4 Close the transceiver's latch (latch styles vary).
5 Connect the fiber optic cables to the transceiver.

Figure 10 Transceiver Installation Example

Figure 11 Connecting the Fiber Optic Cables

3.1.3.2 Transceiver Removal
Use the following steps to remove a mini-GBIC transceiver (SFP module).
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver's latch (latch styles vary).
3 Pull the transceiver out of the slot.

Figure 12 Removing the Fiber Optic Cables

Figure 13 Opening the Transceiver's Latch Example

44
GS-3012/GS-3012F User's Guide