Configuring The Switch - ZyXEL Communications GS-3012F/3012 User Manual

Table 2 LED Descriptions (continued)
LED COLOR
1000 Green
(GS-
3012F)
100 (GS- Amber
3012F)
MGMT
10 Green
100 Amber

3.4 Configuring the Switch

You may use the embedded web configurator or command line interface to configure the
Switch. If you're using the web configurator, you need Internet Explorer 5.5 and later or
Netscape Navigator 6 and later.
You can access the command line interface using a terminal emulation program on a computer
connected to the Switch console port (see
Telnet.
The next part of this guide discusses configuring the Switch using the web configurator.
GS-3012/GS-3012F User's Guide
STATUS DESCRIPTION
Blinking The system is transmitting/receiving to/from an Ethernet network.
On The link to a 1000 Mbps Ethernet network is up.
Off The link to a 1000 Mbps Ethernet network is down.
Blinking The system is transmitting/receiving to/from an Ethernet network.
On The link to a 100 Mbps Ethernet network is up.
Off The link to a 100 Mbps Ethernet network is down.
Blinking The system is transmitting/receiving to/from an Ethernet device.
On The port is connected at 10Mbps.
Off The port is not connected at 10Mbps or to an Ethernet device.
Blinking The system is transmitting/receiving to/from an Ethernet device.
On The port is connected at 100Mbps.
Off The port is not connected at 100Mbps or to an Ethernet device.
Section 3.1.1 on page
Chapter 3 Hardware Overview
42) or access the Switch using
47