Link Aggregation Control Protocol; Table 37 Advanced Application > Link Aggregation > Link Aggregation Setting - ZyXEL Communications GS-3012F/3012 User Manual

Chapter 15 Link Aggregation
The following table describes the labels in this screen.
Table 37 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL
Link
Aggregation
Setting
Group ID
Active
Port
Group
Apply
Cancel

15.5 Link Aggregation Control Protocol

Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See
link aggregation.
126
DESCRIPTION
This is the only screen you need to configure to enable static link aggregation.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports.
Select this option to activate a trunk group.
This field displays the port number.
Select the trunk group to which a port belongs.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Section 15.2 on page 123 for more information on dynamic
GS-3012/GS-3012F User's Guide