Remote Management Limitations; Remote Management And Nat; Table 57 Menu 24.11 Remote Management Control - ZyXEL Communications Wireless-11g Access Point ZyXEL G-1000 v2 User Manual

The following table describes the fields in this menu.

Table 57 Menu 24.11 Remote Management Control

FIELD
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
Port
Access
Secured Client IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

17.3.5 Remote Management Limitations

Remote management over LAN or WAN will not work when:
1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
2 You have disabled that service in menu 24.11.
3 The IP address in the Secured Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the G-1000 v2 will disconnect the session immediately.
4 There is already another remote management session of the same type (Telnet, FTP or
Web) running. You may only have one remote management session of the same type
running at one time.
5 There is a web remote management session running with a Telnet session. A Telnet
session will be disconnected if you begin a web session; it will not begin if there already
is a web session.

17.4 Remote Management and NAT

When NAT is enabled:
• Use the G-1000 v2's WAN IP address when configuring from the WAN.
• Use the G-1000 v2's LAN IP address when configuring from the LAN.
Chapter 17 System Maintenance and Information
DESCRIPTION
Each of these read-only labels denotes a server or service that you may use to
remotely manage the G-1000 v2.
This field shows the port number for the remote management service. You may
change the port number for a service if needed, but you must use the same
port number to use that service for remote management.
Select the access interface (if any) by pressing the [SPACE BAR]. Choices are:
LAN only, WAN only, All or Disable. The default is LAN only.
The default 0.0.0.0 allows any client to use this service to remotely manage the
G-1000 v2. Enter an IP address to restrict access to a client with a matching IP
address.
ZyXEL G-1000 v2 User's Guide
129