Table of Contents
Advertisement
This chapter describes how to access the SMT and provides an overview of its menus
10.1 Connect to your G-1000 v2 Using Telnet
The following procedure details how to telnet into your G-1000 v2.
1 In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.2" (the default IP address) and click OK.
2 For your first login, enter the default password "1234". As you type the password, the
screen displays an asterisk "*" for each character you type.
Figure 43 Login Screen
3 After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period)
after you log in, your G-1000 v2 will automatically log you out. You will then have to telnet
into the G-1000 v2 again. You can use the web configurator or the CI commands to change the
inactivity time out period.
10.2 Changing the System Password
Change the G-1000 v2 default password by following the steps shown next.
1 From the main menu, enter 23 to display Menu 23 – System Security.
2 Enter 1 to display Menu 23.1 – System Security – Change Password as shown next.
3 Type your existing system password in the Old Password field, and press [ENTER].
Figure 44 Menu 23.1 System Security: Change Password
Chapter 10 Introducing the SMT
Introducing the SMT
Password: xxxx
Menu 23.1 - System Security - Change Password
Old Password= ?
New Password= ?
Retype to confirm= ? Menu 23.1 - System
ZyXEL G-1000 v2 User's Guide
C
H A P T E R
1 0
.
93
Advertisement
Table of Contents
Troubleshooting
