Tftp File Upload; Figure 17-7 Ftp Session Example - ZyXEL Communications Wireless Access Point ZyAIR B-500 User Manual

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
More commands that you may find in third party FTP clients, are listed earlier in this chapter.

17.4.4 TFTP File Upload

The ZyAIR also supports the up/downloading of the firmware and the configuration file using TFTP
(Trivial File Transfer Protocol) over LAN. Although TFTP should work over WAN as well, it is not
recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware and the
configuration file, follow the procedure shown next:
Step 1.
Use telnet from your computer to connect to the ZyAIR and log in. Because TFTP does not have
any security checks, the ZyAIR records the IP address of the telnet client and accepts TFTP
requests only from this address.
Step 2. Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System
Maintenance.
Step 3.
Enter the command "sys stdio 0" to disable the SMT timeout, so the TFTP transfer will not be
interrupted. Enter command "sys stdio 5" to restore the five-minute SMT timeout (default) when
the file transfer is complete.
Step 4. Launch the TFTP client on your computer and connect to the ZyAIR. Set the transfer mode to
binary before starting data transfer.
Step 5. Use the TFTP client (see the example below) to transfer files between the ZyAIR and the
computer. The file name for the firmware is "ras" and the configuration file is "rom-0" (rom-
zero, not capital o).
Note that the telnet connection must be active and the SMT in CI mode before and during the TFTP
transfer. For details on TFTP commands (see following example), please consult the documentation of your
TFTP client program. For UNIX, use "get" to transfer from the ZyAIR to the computer, "put" the other way
around, and "binary" to set binary transfer mode.
Firmware and Configuraiton File Maintenance
ZyAIR B-500 Wireless Access Point User's Guide

Figure 17-7 FTP Session Example

17-9