Problems With The Password; Problems With Telnet - ZyXEL Communications Wireless Access Point ZyAIR B-500 User Manual

ZyAIR B-500 Wireless Access Point User's Guide
PROBLEM
I cannot ping any
computer on the
LAN.

Problems with the Password

PROBLEM
I cannot access
the ZyAIR.

Problems with Telnet

PROBLEM
I cannot access
the ZyAIR through
Telnet.
A-2
Chart A-2 Troubleshooting the Ethernet Interface
If the ETHN LED on the front panel is off, check the Ethernet cable connections
between your ZyAIR and the Ethernet device.
Check the Ethernet cable connections between the Ethernet device and the LAN
computers.
Check for faulty Ethernet cables.
Make sure the LAN computer's Ethernet adapter is installed and working properly.
Verify that the IP address and the subnet mask of the ZyAIR, the Ethernet device
and the LAN computers are on the same subnet.
Chart A-3 Troubleshooting the Password
The Password and Username fields are case-sensitive. Make sure that you enter
the correct password and username using the proper casing.
Use the RESET button on the top panel of the ZyAIR to restore the factory default
configuration file (hold this button in for about 10 seconds or until the link LED turns
red). This will restore all of the factory defaults including the password.
Chart A-4 Troubleshooting Telnet
Refer to the Problems with the Ethernet Interface section for instructions on checking
your Ethernet connection.
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
Troubleshooting