Example: Tftp Command - ZyXEL Communications Wireless Access Point ZyAIR B-500 User Manual

ZyAIR B-500 Wireless Access Point User's Guide

17.4.5 Example: TFTP Command

The following is an example TFTP command:
TFTP [-i] host put firmware.bin ras
where "i" specifies binary image transfer mode (use this mode when transferring binary files), "host" is the
ZyAIR's IP address, "put" transfers the file source on the computer (firmware.bin – name of the firmware
on the computer) to the file destination on the remote host (ras - name of the firmware on the ZyAIR).
Commands that you may see in third party TFTP clients are listed earlier in this chapter.
17-10 Firmware and Configuraiton File Maintenance