Figure 51 Advanced; Table 39 Advanced - ZyXEL Communications P-335WT User Manual

Figure 51 Advanced

The following table describes the labels in this screen.

Table 39 Advanced

LABEL
Roaming Configuration
Enable
Roaming
Port
Wireless Advanced Setup
RTS/CTS
Threshold
Fragmentation
Threshold
Preamble
802.11 Mode
G+ Enhanced
Apply
Reset
Chapter 5 Wireless LAN (P-335WT)
DESCRIPTION
Select the check box to enable roaming on the Prestige if you have two or more
Prestiges on the same subnet.
Note: All APs on the same subnet and the wireless stations must
have the same SSID to allow roaming.
Enter the port number to communicate roaming information between APs. The port
number must be the same on all APs. The default is 3517. Make sure this port is not
used by other services.
Enter a value between 0 and 2432. If you select the G+ Enhanced checkbox a value
of 4096 is displayed.
It is the maximum data fragment size that can be sent. Enter a value between 256 and
2432. If you select the G+ Enhanced checkbox a value of 4096 is displayed.
Select a preamble type from the drop-down list menu. Choices are Long, Short or
Dynamic. The default setting is Long. See the section on preamble for more
information.
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the Prestige.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the Prestige.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices
to associate with the Prestige. The transmission rate of your Prestige might be
reduced.
Select G+ Enhanced checkbox to allow any ZyXEL WLAN devices that support this
feature to associate with the Prestige at higher transmission speeds. This permits the
Prestige to transmit at a higher speed than the 802.11g Only mode.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
P-335 Series User's Guide
102