Otist Button; Mac Filter; Figure 48 Otist Start; Figure 49 Otist Process - ZyXEL Communications P-335WT User Manual

Figure 48 OTIST Start

Note: The process takes three minutes. During this time the Prestige assigns its
security settings to OTIST-enabled wireless clients within range that have selected to
associate with this Prestige.

Figure 49 OTIST Process

When the previous screen closes, your current Prestige security configuration is automatically
saved to the wireless clients.
Note: See your wireless client documentation for information on enabling OTIST on it.
If there are multiple OTIST-enabled Prestiges within range and with the same OTIST
setup key, then the wireless client must choose which Prestige should assign its
settings to it.

5.5.2 OTIST button

Use the OTIST button to set up OTIST using the current OTIST Setup Key and the Prestige's
current wireless security settings.
1 Log out of your current configuration management session.
2 Push the OTIST button once on the back panel of the Prestige device to enable OTIST.

5.6 MAC Filter

The MAC filter screen allows you to configure the Prestige to give exclusive access to up to
32 devices (Allow ) or exclude up to 32 devices from accessing the Prestige (Deny ). Every
Ethernet device has a unique MAC (Media Access Control) address. The MAC address is
assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure this
screen.
To change your Prestige's MAC filter settings, click the Wireless LAN link under Network
and then the MAC Filter tab. The screen appears as shown.
Chapter 5 Wireless LAN (P-335WT)
P-335 Series User's Guide
100