Troubleshooting - ZyXEL Communications 802.11g Wireless Firewall Router 1-P-320W Quick Start Manual

Internet Access Setup Complete
If you have any Internet access problems, follow the
on-screen instructions.
Click Finish to complete the Connection Wizard.

4 Troubleshooting

Note: If your computer cannot automatically communicate with the device, then see the multimedia
tutorial on how to set up your computer to receive an IP address dynamically or give it a fixed
one in the range specified in section
PROBLEM
None of the LEDs turn on when
you connect the Mer
produkthjalp finns pa http://
www.support.zyxel.se's power.
Cannot access the Mer
produkthjalp finns pa http://
www.support.zyxel.se from my
computer.
ENGLISH
.
4.1
CORRECTIVE ACTION
Make sure that you have the correct power adaptor connected to the Mer
produkthjalp finns pa http://www.support.zyxel.se, it is plugged into an
appropriate power source.
Check all cable connections. If the LEDs still do not turn on, you may have a
hardware problem. In this case, you should contact your local vendor.
Check the cable connection from your computer to the Mer produkthjalp finns
pa http://www.support.zyxel.se.
If the Mer produkthjalp finns pa http://www.support.zyxel.se's IP address has
changed, then enter the new one as the website address.
Make sure your computer's IP address is in the same subnet as the Mer
produkthjalp finns pa http://www.support.zyxel.se's IP address (see section 4.1).
Ping the Mer produkthjalp finns pa http://www.support.zyxel.se from a computer
on the LAN. Make sure your computer's Ethernet adapter is installed and
functioning properly. In the computer, click Start, (All) Programs, Accessories
and then Command Prompt. In the Command Prompt window, type "ping"
followed by the Mer produkthjalp finns pa http://www.support.zyxel.se's LAN IP
address (192.168.1.1 is the default) and then press [ENTER]. The Mer
produkthjalp finns pa http://www.support.zyxel.se should reply; otherwise see
section 4.1.
17