The following table describes the labels in this screen.
Table 13 Station Mode: Profile: Select a Channel
LABEL
Wireless Settings
Channel
3 If you select Infrastructure network type in the first screen, select WEP, WPA-PSK,
WPA-RADIUS or RADIUS from the drop-down list box to enable data encryption. If
you select Ad-Hoc network type in the first screen, you can only use WEP encryption
method. Otherwise, select Disabled to allow the ZyAIR to communicate with the access
points or other peer wireless computers without any data encryption and skip to step 5.
Figure 22 Station Mode: Profile: Wireless Settings
4 The screen varies depending on the encryption method you select in the previous screen.
The settings must be exactly the same on the APs or other peer wireless computers as
they are on the ZyAIR. Refer to
information on wireless security configuration.
Chapter 3 Wireless Station Mode Configuration
DESCRIPTION
Select a channel number from the drop-down list box. To associate to an ad-hoc
network, you must use the same channel as the peer computer.
Section 3.3.2 "Security Settings" on page 34
ZyAIR B-220 User's Guide
for detailed
44