Bandwidth Monitor; Figure 139 Bandwidth Management: Monitor - ZyXEL Communications Network Device P-2602 User Manual

P-2602H(W)(L)-DxA Series User's Guide
Table 103 Bandwidth Management Rule Configuration (continued)
LABEL
Source Subnet
Netmask
Source Port
Protocol
Back
Apply
Cancel

19.9 Bandwidth Monitor

To view the ZyXEL Device's bandwidth usage, click Advanced > Bandwidth MGMT >
Monitor. The screen appears as shown. Select an interface from the drop-down list box to
view the bandwidth usage of its bandwidth rules. The gray section of the bar represents the
percentage of unused bandwidth and the blue color represents the percentage of bandwidth in
use.

Figure 139 Bandwidth Management: Monitor

262
DESCRIPTION
Enter the destination subnet mask. This field is N/A if you do not specify a
Source Address. Refer to the appendix for more information on IP subnetting. A
blank source port means any source port number.
Enter the port number of the source. See
common services and port numbers.
Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number. 0 means any protocol number.
Click Back to go to the previous screen.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
Appendix 31 on page 371
Chapter 19 Bandwidth Management
for some