ZyXEL Communications Network Device P-2602 User Manual page 232

P-2602H(W)(L)-DxA Series User's Guide
Table 87 Edit VPN Policies
LABEL
Remote
Remote Address
IP Address Start When the Remote Address Type field is configured to Single, enter a (static) IP
End / Subnet Mask When the Remote Address Type field is configured to Single, this field is N/A.
Address
Information
Local ID Type Select IP to identify this ZyXEL Device by its IP address.
My IP Address Enter the WAN IP address of your ZyXEL Device. The VPN tunnel has to be
232
DESCRIPTION
Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses. The remote fields do not apply when the Secure
Gateway IP Address field is configured to 0.0.0.0. In this case only the remote
IPSec router can initiate the VPN.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You
can configure multiple SAs between the same local and remote IP addresses, as
long as only one is active at any time.
Use the drop-down menu to choose Single, Range, or Subnet. Select Single
Type with a single IP address. Select Range for a specific range of IP addresses.
Select Subnet to specify IP addresses on a network by their subnet mask.
address on the network behind the remote IPSec router. When the Remote
Address Type field is configured to Range, enter the beginning (static) IP
address, in a range of computers on the network behind the remote IPSec router.
When the Remote Address Type field is configured to Subnet, enter a (static) IP
address on the network behind the remote IPSec router.
When the Remote Address Type field is configured to Range, enter the end
(static) IP address, in a range of computers on the network behind the remote
IPSec router. When the Remote Address Type field is configured to Subnet,
enter a subnet mask on the network behind the remote IPSec router.
Select DNS to identify this ZyXEL Device by a domain name.
Select E-mail to identify this ZyXEL Device by an e-mail address.
Content When you select IP in the Local ID Type field, type the IP address of your
computer in the local Content field. The ZyXEL Device automatically uses the IP
address in the My IP Address field (refer to the My IP Address field description)
if you configure the local Content field to 0.0.0.0 or leave it blank.
It is recommended that you type an IP address other than 0.0.0.0 in the local
Content field or use the DNS or E-mail ID type in the following situations.
When there is a NAT router between the two IPSec routers.
When you want the remote IPSec router to be able to distinguish between VPN
connection requests that come in from IPSec routers with dynamic WAN IP
addresses.
When you select DNS or E-mail in the Local ID Type field, type a domain name
or e-mail address by which to identify this ZyXEL Device in the local Content field.
Use up to 31 ASCII characters including spaces, although trailing spaces are
truncated. The domain name or e-mail address is for identification purposes only
and can be any string.
rebuilt if this IP address changes.
The following applies if this field is configured as 0.0.0.0:
The ZyXEL Device uses the current ZyXEL Device WAN IP address (static or
dynamic) to set up the VPN tunnel.
If the WAN connection goes down, the ZyXEL Device uses the dial backup IP
address for the VPN tunnel when using dial backup or the LAN IP address when
using traffic redirect. See
traffic redirect.
Chapter 7 on page 93 for details on dial backup and
Chapter 17 VPN Screens