Bandwidth Management Rule Setup; Figure 137 Bandwidth Management: Rule Setup; Table 102 Bandwidth Management: Rule Setup - ZyXEL Communications Network Device P-2602 User Manual

Table 101 Media Bandwidth Management: Summary (continued)
LABEL
Max
Bandwidth
Usage
Apply
Cancel

19.8 Bandwidth Management Rule Setup

You must use the Bandwidth Management Summary screen to enable bandwidth
management on an interface before you can configure rules for that interface.
Click Advanced > Bandwidth MGMT > Rule Setup to open the following screen.

Figure 137 Bandwidth Management: Rule Setup

The following table describes the labels in this screen.

Table 102 Bandwidth Management: Rule Setup

LABEL
Direction
Service
Priority
Chapter 19 Bandwidth Management
DESCRIPTION
Select this check box to have the ZyXEL Device divide up all of the interface's
unallocated and/or unused bandwidth among the bandwidth classes that require
bandwidth. Do not select this if you want to reserve bandwidth for traffic that does not
match a bandwidth class or you want to limit the transmission speed of this interface
(see the Speed field description).
Click Apply to save your settings back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select LAN to apply bandwidth management to traffic that the ZyXEL Device
forwards to the LAN.
Select WAN to apply bandwidth management to traffic that the ZyXEL Device
forwards to the WAN.
Select WLAN to apply bandwidth management to traffic that the ZyXEL Device
forwards to the WLAN.
Select a service for your rule or you can select User define to go to the screen
where you can define your own.
Select a priority from the drop down list box. Choose High, Mid or Low.
P-2602H(W)(L)-DxA Series User's Guide
259