Ricoh FAX5600L Technical Bulletin page 26

TROUBLESHOOTING
ERROR CODES
Code Meaning
6-01 ECM - no V.21 signal was
received
6-02 ECM - EOR was received
6-05 Facsimile data frame not
received within 18 s of
CFR, but there was no
line fail (G3 ECM)
6-06 Coding/decoding error
(G3 ECM)
6-08 PIP/PIN received in reply
to PPS.NULL (G3 ECM)
6-09 ERR received (G3 ECM)
6-10 Error frames still received
at the other end after all
communication attempts
at 2400 bps (G3 ECM)
9-07 Copy jam at the cassette
entrance
9-08 Copy jam inside the
machine
9-09 Copy jam in the copy
feed-out area
9-17 Transfer corona power
leak
9-20 Laser diode power
control failed
9-22 Fusing lamp failure
9-23 Hexagonal mirror motor
lock failure, or laser main
scan synch failure
9-24 Main motor lock failed
9-50 Copy jam in the PFU
Suggested Cause/Action
Try adjusting the rx cable equalizer.
Replace the FCU or NCU.
Check the line connection.
Check connections from the FCU to the NCU.
Check for a bad line or defective remote terminal.
Replace the FCU, NCU or MBU.
Switch the rx cable equalizer on (bit switch 0A, bit 6).
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the tx levels of the communicating machines.
See code 6-05.
Check for line noise.
Adjust the tx level (use NCU parameter 01or the
dedicated tx parameter for that address).
Check the line connection.
Defective remote terminal.
See section 6-2-2.
If the problem remains, replace the FCU.
See section 6-2-2.
If the problem remains, replace the FCU.
See section 6-2-2.
If the problem remains, replace the FCU.
See section 6-3 (Charger Leak).
If the problem remains, replace the FCU.
See section 6-3 (LD Power Control Failure).
If the problem remains, replace the FCU.
See section 6-3 (Hot Roller Down).
If the problem remains, replace the FCU.
See section 6-3 (Mirror Motor Locked).
If the problem remains, replace the FCU.
See section 6-3 (Main Motor Locked).
If the problem remains, replace the FCU.
See section 6-2-2.
If the problem remains, replace the FCU.
6-25
1st August, 1994