Clean-Up After Installation - Kohler PRELUDE K-8266T Manual

CLEAN-UP AFTER INSTALLATION

CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, do not use abrasive
cleansers as they may scratch and dull the surface.
Use warm water and liquid, non-abrasive detergent to
clean the surface.
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact
with the bath surface for long periods of time. Plaster
can be removed by scraping with wood edge. Do not
use metal scrapers, wire brushes, or other metal tools.
One of the powder type detergents may be used on a
damp cloth to provide mild abrasive action to the
residual plaster.
IMPORTANT CONSUMER INFORMATION
Housekeeping Responsibilities
The Safeguard slip resistant surface on this bathtub
meets or exceeds the requirements of ASME/ANSI
A112.19.1M slip resistance.
DANGER!! Improper maintenance or cleansers may
permanently remove the slip resistant
surface on Kohler bathtubs.
NOTICE: All housekeeping and maintenance
employees must be trained in the proper
cleaning of Kohler bathtubs. Post a copy of
this notice in a readily-visible location.
DO NOT use steel wool, wire brushes, metal scrapers
or abrasive sponge pads to clean a Kohler
bath tub.
DO NOT use buffing machines on the slip resistant
surface.
DO NOT use high alkaline or strong acid cleansers.
DO NOT use abrasive cleansers.
!
Use only non-abrasive cleansers and a soft nylon
brush to clean the slip resistant surface.
!
When using commercial cleansers, use cleansers
with a pH of between three and eight.
!
Follow cleanser manufacturer instructions very
carefully.
116867-T01-B
Safeguard
for
A112.19.1M
·
· pH 3 8
)
·
8
ASME/ANSI
(