Table of Contents
Advertisement
B.
INTEGRAL FLANGE MODELS
Tape and mud the water-resistant wall material. Install
the finish wall to the water-resistant wall material as
shown. Seal the joints between the whirlpool rim and the
finish wall material with silicone sealant.
15. COMPLETE INSTALLATION
A. INSTALL HANDLES AND SPOUT
Install the faucet handles and spout according to the
manufacturer's instructions. Seal around the plumbing
fittings.
16. CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, do not use
abrasive cleansers as they may scratch and dull the
bath surface. Use warm water and a liquid detergent to
clean the surface.
17. CONFIRM PROPER OPERATION
A. START-UP WHIRLPOOL
Refer to Important Safety Instructions on Page 2.
Please perform the following so the owner can safely
receive the benefits of whirlpool bathing.
1.
Rotate the jets so they are facing down toward the
basin.
2.
Fill the whirlpool to a water level at least 2" above
the top of the highest jet.
Water temperature in the bath should not exceed
104_F (40_C).
EA
113867-2-
(-)
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in
contact with whirlpool surfaces for long periods of
time. Plaster can be removed by scraping with a wood
edge. Do not use metal scrapers, wire brushes, or other
metal tools. A powder-type detergent may be used on a
damp cloth to provide mild abrasive action to the residual
plaster.
Bath
2" Minimum
Wall
18
2x4 Studding
Water-Resistant
Wall Material
Finish Wall
Silicone
Sealant
Whirlpool
Water Line
Jet Trim
Kohler Co., Kohler WI
Advertisement
Table of Contents
