Bushnell WIRELESS Trophy Cam HD Instruction Manual page 42

7. Short video clips—not recording to the length set
• Check to make sure that the SD card is not full.
• Make sure that the camera has good batteries in it. Near the end
of the battery life, the camera may choose to record shorter video
clips (or even stop recording video, only still photos) to conserve
power.
Date/Time Stamp not appearing on images
Make sure that the "Time Stamp" parameter is set to "On".
Photos Do Not Capture Subject of Interest
1. Check the "Sensor Level" (PIR sensitivity) parameter setting. For warm
temperature conditions, set the Sensor Level to "High" and for cold
weather use, set the sensor for "Low". For variable weather, use "Auto".
2. Try to set your camera up in an area where there is not a heat source in
the camera's line of sight.
3. In some cases, setting the camera near water will make the camera take
images with no subject in them. Try aiming the camera over ground.
4. Try to avoid setting the camera up on small trees that are prone to being
moved by strong winds.
5. Remove any limbs that are right in front of the camera lens.
PIR Sensor LED Flashes/Doesn't Flash
1. When the camera is in the "Setup" mode, a special LED on the front of the
camera will flash when it senses motion. This is for setup purposes only
and will help the user aim the camera.
2. During use, the LED will not flash when the camera takes an image. This
is to help keep the camera hidden from game.
LCD Screen Issues
1. LCD screen powers on but no text is present.
• After moving the switch from "Off" to "Setup" or "On", make sure
that the switch is correctly in position to ensure the proper mode
(avoid positions "between" two modes).
• Do not move the switch directly from "On" to "Setup"-always
move the switch all the way down to "Off" first, then back up to
"Setup".
42