Bushnell WIRELESS Trophy Cam HD Instruction Manual page 18

adjust the date and time, using the "Set Clock" parameter in the SETUP Menu.
Field Scan 2x with Live Trigger Feature
Field Scan is a revolutionary new feature for the Bushnell WIRELESS Trophy
Cam HD, which allows you to monitor your food plots or field edges with time
lapse images or video. When set to "On", the WIRELESS Trophy Cam HD will
take a photo (or record a video clip) automatically at your choice of intervals
(for example, once every five minutes) during one or two blocks of time you
set up for each day, without requiring a trigger from an active animal. This
has the advantage of giving you the ability to monitor the edge of a field that
might be 50 or 150 yards away from the camera out of the PIR sensor's range.
The result is an effective range much greater than it would normally be, with
the camera dependant on triggers generated by nearby animals. This is a
great tool to scout an entire field with only one camera.
If an animal does enter the area covered by the PIR sensor and generate a
trigger event during a time in between the Field Scan intervals you set, the
camera will capture an image or video just as it normally would, based on your
other menu settings. Here's how to setup and use Field Scan (be sure you've
set the current time in "Set Clock" first, so your Field Scan recording will stop
and start at the correct times of day):
1. Move the main switch to SETUP, then press MENU.
2. Keep pressing the RIGHT key, stepping through the Setup Menu until
you reach Set Field Scan.
3. Press the UP key to select On, and press OK (Step 1, pg. 20). You will
see "A", representing the first block of time you can define (a second
block of time later in the day, "B" can also be setup if you wish). Press
OK (Step 2). This takes you to the screen to set Start and Stop times,
which determines the clock times when the first block of Field Scan
recording will begin and end for each day. You can set these times to
the exact hour and minute you want, for a recording "window" that lasts
anywhere from just a minute to a full 24 hours.
4. Set the [Start] and [Stop] times, beginning with the Start hour, using
the UP/DOWN keys to change the setting (Step 3). The hour setting is
based on a 24-hour clock, with "00" hours = midnight, "12" hours = noon,
"23" hrs = 11PM, etc. To move to the next setting, press the RIGHT key,
18