Table of Contents
Advertisement
TCX1000 Programmable ROADM Quick Start Guide
Step 5: Connect the TCX1000-RDM20 to a Management Console
6
To connect a grounding cable to the TCX1000-RDM20:
Attach an ESD grounding strap to your bare wrist, and connect the strap to an approved
1.
site ESD grounding point. See the instructions for your site.
Connect one end of the grounding cable to a proper site earth ground, such as the
2.
rack in which the TCX1000-RDM20 is mounted.
Strip the appropriate length of wire for the ground lug type used, and verify that a
3.
licensed electrician has attached the cable lug provided with the TCX1000-RDM20
to the grounding cable.
Attach the grounding lug, lock washers, and hex nut as shown in
4.
Figure 3: Connecting a Grounding Cable to the TCX1000-RDM20
Dress the grounding cable and ensure that it does not touch or block access to other
5.
device components and that it does not drape where people could trip over it.
You can configure and manage the TCX1000-RDM20 by using a dedicated console. Use
the console port to connect the device directly to a management console, such as a
laptop, or a console server.
The TCX1000-RDM20 has a console port (labeled
Ensure that you have an RJ-45 to DB-9 rollover cable available.
Figure 3 on page
) with a DB-9 connector.
SERIAL
Copyright © 2018, Juniper Networks, Inc.
6.
Advertisement
Table of Contents
