Audio Input And Output - Yamaha Clavinova CVP-105 Owner's Manual

Audio and Video Connections
X Set the input level.
Set the [MIC/LINE] switch (located next to the [MIC.] jack) to the
MIC position.
C Adjust the microphone volume.
Use the [MIC. VOL.] knob (located next to the [MIC.] jack) to set the
microphone volume, then trying singing into the microphone. The vol-
ume should be set high enough that the [SIGNAL] lamp on the front
panel lights steadily when you sing, but not so high that the [OVER]
lamp lights. (These two lamps can be found at the left end of the panel,
next to the [VOCAL HARMONY] button.)

Audio Input and Output

You can connect the Clavinova to a wide range of audio equipment by
using the AUX IN and AUX OUT jacks, which are located at the left end
of the unit on the underside (CVP-109/107/700) or rear panel (CVP-105).
AUX IN Jacks
+
L/L R
AUX IN
Tone Generator
214
CVP-109/107/105/700
...........................................................................................
MIC/LINE
MIC/LINE
...........................................................................................................
The sounds of other instruments or
tone generator modules can be output
through the speaker system of the
R
Clavinova by connecting audio cables to
the AUX IN jacks as shown here.
Use the AUX IN [L/L+R] jack for
monophonic input. For stereo input, con-
nect the left channel output to the AUX
IN [L/L+R] jack, and the right channel
output to the AUX IN [R] jack.
.......................................................
You should set the [MIC/LINE] switch to
the LINE position when connecting an
audio source with line-level output to the
[MIC.] jack.
The Vocal Harmony function (page 175)
may not work properly if the [OVER] lamp
lights during microphone use.
CAUTION
Never connect the Clavinova's AUX
OUT jacks to its AUX IN jacks, either
directly or via external audio equip-
ment. Such connections could result
in a feedback loop that will make nor-
mal performance impossible, and may
even damage the Clavinova.
The volume of the audio signal input at
the AUX IN jacks is affected by the
[MASTER VOLUME] slider.