Static Routing - XiNCOM Twin WAN XC-DPG402 User Manual

•
Host Network
Binding
•
•
Note: Multiple PPPoE sessions are defined on the Advanced PPPoE screen.
•
Buttons
•
•
•
Host & Group This table shows the current bindings.
List

Static Routing:

If there is more than one router on a network, this Routing table must be configured because the
router needs to know what packet goes to which router. A routing table entry is required for each
LAN segment on the network.
Static Routing Entry:
Bind WAN port/Session – Select Enable if you wish to associate this PC with
a particular PPPoE Session. All traffic for that PC will then use the selected
PPPoE port and session.
Binding Method – Suppose your PC is bound to WAN1 port, now you are
selecting "Strict Binding". If WAN1 port is disconnected, your packets cannot
go out through WAN2 port, if WAN2 port is still alive. If you are selecting
"Loose Binding" then when WAN1 port is disconnected, your packets will
automatically go to WAN2, if WAN2 is alive.
Select WAN Port/Select PPPoE session – If the setting above is Enable,
select the desired Port and Session. Otherwise, ignore these settings.
Add – Use this to add a new entry to the database, using the data shown on
screen.
Delete – Click this to delete the selected entry.
Update – Use this to update the selected entry, after making the desired
changes.
Reset – Reverse any changes you have made since loading the data from the
XC-DPG Twin WAN Router.
Figure 144: Static Routing Setup
XiNCOM Corp.
Page 29