Policy Configuration - XiNCOM Twin WAN XC-DPG402 User Manual

Policy Configuration

When you use Qo S, you must define some policies to make some packets to have higher priority
to pass through.
Data – Policy Configuration.
Network This section identifies each policy
Admission
•
Policy
•
•
•
•
•
•
•
Figure 33: Policy Configuration.
Po licy Name List – When adding a new Policy, ignore this list. To edit an
existing entry, select it from the list, and click the "Select" b
fields will then be updated with data for the selected entry.
Policy Name – Enter a suitable name. Generally, you should use the "Policy
Name" for the network traffic.
Source Address – Define the source address of packets here. It has two
types like IP address or MAC address. If you select IP address, you can
define IP address range, otherwise define up to four MAC addresses.
Destination A ddress – Define the destination address of packets here. The
explanation is as the same as above.
Protocol Type – The field defines traffic packet type, i.e. IP
Source Port – Define the source port of packets here.
Destination Port – Define the destination port of packets here.
Priority Queue – It defines a packet if it meets all conditions defined above, it
will be serviced with some priority level.
XiNCOM Corp.
utton. The data
,TCP and UDP.
Page 53