2: Basic Setup; Overview; 1: Configuring The Xc-Dpg Twin Wan Router For Your Lan - XiNCOM Twin WAN XC-DPG402 User Manual

2: Basic Setup

Overview

Basic Setup of your XC-DPG Twin WAN Router involves the following steps:
1. Connect the XC-DPG Twin WAN Router to one (1) PC, and configure it for your LAN.
2. Connect your XC-DPG Twin WAN Router to your LAN, and connect the Broadband Modem or
Modems.
3. Configure your XC-DPG Twin WAN Router for Internet Access.
4. Configure PCs on your LAN to use the XC-DPG Twin WAN Router.
Requirements
•
One (1) or two (2) DSL or Cable modems, each with an Internet Access account with an ISP.
•
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors
•
TCP/IP network protocol must be installed on all PCs.
1: Configuring the XC-DPG Twin WAN Router for your
LAN
1. Using the included LAN cable, connect your computer to one of the routers LAN ports.
2. Connect the power adapter and power up the XC-DPG Twin WAN Router. Only use the power
adapter provided; using a different one may cause hardware damage.
3. Start your PC. If your PC is already running, restart. It will then obtain a new IP address from the
XC-DPG Twin WAN Router.
4. Start your default WEB browser.
5. In the Address or Location box enter:
HTTP://192.168.1.1
6. You will be prompted for the User Name and password, as shown below.
Figure 4: Password Dialog
XiNCOM Corp.
Page 10