Labels - Xerox WorkCentre PE220 User Manual

Labels

Xerox PE220
Be sure the seam extends all the way to the corner of the envelope as
illustrated below.
Correct
Incorrect
Envelopes with Adhesive Strips or Flaps
Envelopes with a peel-off adhesive strip or with more than one flap that folds
over to seal must use adhesives compatible with the heat and pressure in the
machine. The extra flaps and strips might cause wrinkling, creasing or even
jams and may even damage the fuser.
Envelope Margins
The following gives typical address margins for a commercial #10 or DL
envelope.
Type of Address
Return address
Delivery address
NOTE:
• For the best print quality, position margins no closer than 0.6 in. (15 mm)
from the edges of the envelope.
• Avoid printing over the area where the envelope's seams meet.
Envelope Storage
Proper storage of envelopes helps contribute to print quality. Envelopes
should be stored flat. If air is trapped in an envelope, creating an air bubble,
then the envelope may wrinkle during printing.
CAUTION:
– To avoid damaging the machine, use only labels recommended for
laser printers.
Minimum
0.6 in. (15 mm)
2 in. (51 mm)
10 Specifications
Maximum
2 in. (51 mm)
3.5 in. (90 mm)
10-11