Table of Contents
Advertisement
Chapter 1: Preparing the Emulator
Step 2. Connect the Emulator Probe Cables
Step 2. Connect the Emulator Probe Cables
Three ribbon cables connect the HP 64748C emulation control card to the HP 64780A emulator probe.
The shortest cable connects from J1 of the emulation control card to J3 of the emulator probe. The
medium length cable connects from J2 of the emulation control card to J2 of the emulator probe. The
longest cable connects from J3 of the emulation control card to J1 of the emulator probe.
Make sure the cable connectors are seated. There are stainless steel clips on the cable connectors; these
must be properly latched inside the sockets. Otherwise, the cables will work loose and you will see
erratic operation. See illustration next page (step 2).
1 Connect the emulator probe cables to the emulation control card.
9
Advertisement
Table of Contents
