Connecting The Probe To The Emulator; Figure 4-2. Attaching Grabbers To Probe Wires - HP 64700 series User Manual

Figure 4-2. Attaching Grabbers to Probe Wires

Connecting the
The external analyzer probe is attached to a connector under the
snap-on cover in the front upper right corner of the emulator. Remove
Probe to the Emulator
the snap-on cover by pressing the side tabs toward the center of the
cover; then, pull the cover out. (See figure 4-3.)
Check for bent connector pins before connecting the analyzer probe to
Note
the emulator.
4-4 Using the External Analyzer