Chapter 3: Connecting and Configuring the Analysis Probe
Connecting the Analysis Probe to the Logic Analyzer
To connect the high-density termination cables
to the analysis probe
Four HP E5346A high-density termination cables, and labels to identify
them, are included with the HP E2480A. Connect the cables to the
connectors on the analysis probe as shown in the illustration below.
Attach the labels to the cables after connecting the cables to the logic
analyzer. Note that J1 and J6 are State connectors, and J2 through J5
are Timing connectors.
Connecting High-Density Cables to the Analysis Probe
50
Solutions for CPU32