Table of Contents
Advertisement
Chapter 6: Solving Problems
To display the emulator status
representative. The optional Flash EPROM card can be inserted in an available
slot in the HP 64700A card cage to override old versions of firmware in products
with conventional EPROMs. The host controller in the HP 64700A card cage is
already programmed to look for a Flash EPROM card if one is installed. To obtain
an optional LAN card and/or optional Flash EPROM card, refer to the list of HP
Sales Offices in the Support Services book supplied with this manual.
When you load all your new versions of software onto your host computer, you are
now ready to load the new version of firmware from your host computer to the
assemblies that are in the HP 64700 Card Cage.
To load the new firmware, you use the progflash command. The progflash
command must be run from a PC or workstation; it displays a list of card cages and
subassemblies in each card cage on your system. From these lists, you can select
which product to update. For information on using the progflash command, and
updating your HP 64700 Series firmware, refer to the chapter 5,
"Installing/Updating Emulator Firmware."
To display the emulator status
The emulator status is displayed on a status line in the graphical interfaces. If you
need to display the emulator status using the built-in Terminal Interface:
• Display the emulator status by typing: es
The emulation prompts can usually tell you most information about the emulator's
status: whether the emulator is reset, running a user program, or running in
monitor. If you need more information than is given by the prompt, you can use the
es command.
Example
R>es
68360--Emulation reset
R>
115
Advertisement
Table of Contents
