Clean / Clear Water Iron Removal; Clean Feature Minutes - Whirlpool WHES20 Installation And Operation Manual

Clean / Clear Water Iron Removal

Clean Feature Minutes

This feature is beneficial on water supplies containing iron and/or high amounts of sediments (sand,
silt, dirt, etc.). When set to "ON", an additional backwash and fast rinse cycle will occur first,
preceeding the normal regeneration sequence. This provides extra cleaning of the resin bed before it
is regenerated with the salt brine. To conserve water set this feature "OFF" if your water supply does
not contain iron or sediments.
1. Press and hold the
Once in this display, press the
is shown. Both displays will show the word "Clean".
+
2. Press the Up or
Adjust the length of the Clean/Clear Water Iron Removal feature, from 1 to 15 minutes in length. To
change this cycle time, use the UP button to increase the time, or the DOWN button to shorten the time.
If you are using this feature the length of the extra backwash cycle automatically sets to 3 minutes.
1. Press and hold the
Once in this display, press the
+
2. Press the Up or
PROGRAM button until the following screen is displayed.
PROGRAM button twice and one of the following two displays
−
Down buttons to set On or Off.
PROGRAM button until the following screen is displayed.
PROGRAM button three times and following display is shown.
−
Down buttons to set number of minutes.
25