Set Water Hardness Number
Set Recharge (Regeneration) Time
Start a Recharge
18
1. Press the
PROGRAM button once again to display a flashing 25 and the word "HARDNESS".
+
2. Press the
Up or
NOTE:
Be sure to enter the grains per gallon (gpg) hardness of your water supply on page 5, for
future reference. If your water supply contains iron, compensate for it by adding to the
water hardness number. For example, assume your water is 20 gpg hard and contains 2
ppm iron. Add 5 to the hardness number for each 1 ppm of iron. In this example, you
would use 30 for your hardness number.
2 ppm iron x 5 = 10
1. Press the
PROGRAM button once again to display a flashing 2:00AM and the words
"RECHARGE TIME". This is a good time for the recharge to start in most households because
water is not in use.
If you want to change the recharge start time, press the
desired starting time shows.
2. Press the
PROGRAM button once again to return to normal operating display.
Press the
RECHARGE button and hold for three seconds until the word "Recharge" begins to flash
in the timer display, starting a recharge. This recharge draws the sanitizing bleach into and through the
water softener. Any air remaining in the water softener is purged to the drain.
If you have questions about installation, electronic programming, operating and routine maintenance...
call 1- - 866- - 986- - 3223, Monday - - Friday, 8 am to 9 pm, EST.
HARDNESS
−
Down buttons to set your water hardness number.
+10
(times)
RECHARGE
TIME
20 gpg hardness
30 HARDNESS NUMBER
AM
−
+
Up or
Down buttons until the