Clean / Clear Water Iron Removal; Clean Feature Minutes - Whirlpool WHES40 Installation And Operation Manual

Clean / Clear Water Iron Removal
This fcature is beneficial on water supplies containing iron and/or high amounts of sediments (sand,
silt, dirt, etc.). Default setting is "OFF". When set to "ON", an additional backwash and fast rinse cycle
will occur first, preceeding the normal regeneration sequence. This provides extra cleaning of the resin
bed betk)re it is regenerated with the salt brine. To conserve water set this fcature "OFF" if your water
supply does not contain iron or sediments.
1. Press and hold the O PROGRAM button until the tk_llowing screen is displayed.
i-i i'11-1
s_,i_ U ULI
Once in this display, press the O PROGRAM button twice and one of the following two displays
is shown. Both displays will show the word "Clean".
fin tiff:
C/can C/ean
2. Press the _ Up or _ Down buttons to set On or Off.
Clean Feature Minutes
To adjust the length of the Clean/Clear Water Iron Removal feature, from t to 15 minutes in length.
To change this cycle time, use the UP button to increase the time, or the DOWN button to shorten the
time. If you are using this feature the length of the extra backwash cycle automatically sets to 9 minutes.
1. Press and hold the O PROGRAM button until the fi_llowing screen is displayed.
i-i1"11-1
s.,i_ U UU
2.
Once in this display, press the O PROGRAM button three times and following display is shown.
q Mil_,
C/can
Press the _ Up or _ Down buttons to set number of minutes.
21