Product Specifications; Performance Claims - Whirlpool WHES20 Installation And Operation Manual

Product Specifications

Performance Claims

Variable Salt Dose
34
4. Press the RECHARGE button to move the softener into fast rinse. Again look for a fast drain
flow. Allow the softener to rinse for a few minutes to flush out any brine that may remain in the
resin tank from the brining cycle test.
5. To return the softener to service, press the
Rated Service Flow Rate (gpm)
Amount of High Capacity Resin (cu ft)
Pressure Drop at Rated Service Flow (psig)
Water Supply Max. Hardness (gpg)
Water Supply Max. Clear Water Iron (ppm)
Water Pressure Limits (min./max. psi)
Min. --- Max. Water Temperature (˚F)
Min. Water Supply Flow Rate (gpm)
Max. Drain Flow Rate (gpm)
Salt storage capacity
Rated Softening Capacity
(Grains @ Salt Dose)
Rated Efficiency (Grains/Pound of Salt @
Minimum Salt Dose)
These systems conform to NSF/ANSI 44 for the specific performance claims as verified and
substantiated by test data.
The efficiency rating is only valid at the stated salt dose. These softeners were efficiency rated
according to NSF/ANSI Standard 44.
The salt dose is selected by the electronic controls at regeneration time based on the amount needed.
RECHARGE button.
WHES 20
6.0
.57
10
50
3
20 --- 125
40 --- 120
3
2.0
175 lbs.
WHES 20
8,700 @ 1.7 lbs.
16,800 @ 5.4 lbs.
20,100 @ 9.1 lbs.
5000 @1.7 lbs.
WHES 30
8.0
.82
12
95
5
20 --- 125
40 --- 120
3
2.0
175 lbs.
WHES 30
14,700 @ 2.9 lbs.
25,400 @ 8.0 lbs.
30,100 @ 13.1 lbs.
5,000 @2.9 lbs.