Recharge
Recharge Scheduled
Set Salt Level
Customizing Features/Options-- Model WHES30
Recharge button is used to initiate an immediate recharge.
Press and hold the
•
and "FILL" flash in the display, and the softener enters the fill cycle of regeneration right
away. The word "RECHARGE" will flash during the regeneration. When over, full water
conditioning capacity is restored.
NOTE:
Avoid using hot water while the conditioner is regenerating, because the water heater will
refill with bypass hard water.
If you do not want to start an immediate recharge, but would like an extra recharge at the next preset
recharge time, do the following to schedule a recharge.
Press and release (do not hold) the
•
SCHEDULED" flashes in the display, and the softener will recharge at the next recharge
time. The word "RECHARGE" will flash during the regeneration. When over, full water
conditioning capacity is restored.
The water softener has a salt monitor indicator light to remind you to refill the storage tank with salt.
To set this monitor system, lift the salt hole cover and level the salt in the storage tank.
•
The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe
the number the leveled salt is at, or closest to. Now, press the
button until black ovals corespond to the salt level number. At level 2 or below, the
indicator LED will flash "Check Salt Level".
If you want to turn the salt monitor off, press the
•
"SALT LEVEL OFF" shows in display.
RECHARGE button until the words "RECHARGE", "SERVICE"
RECHARGE NOW Initiated
RECHARGE button. The words "RECHARGE
SET SALT LEVEL
SET SALT LEVEL button until
23