Maximum Days Between Regenerations
12 or 24 Hour Clock
26
The water softener automatically controls regeneration frequency. This provides the greatest operating
efficiency, and under most conditions, this feature should be left in this mode. However, modify this
feature if you want to force a regeneration every set number of days. For example, if your water supply
contains iron and you want the softener to regenerate at least once every few days to keep the resin
bed clean, set the display as shown below. Setting is available from 1 to 15 days by using the UP and
DOWN buttons.
NOTE:
The softener will recharge on its own if needed, even if it is before the set number of days.
1. Press and hold the
Once in this display, press the
+
2. Press the
Up or
All time displays are shown in standard clock time (1 to 12 PM; and 1 to 12 AM) at the 12 hr default
setting. If 24 hour clock displays are desired, follow steps below.
1. Press and hold the
Once in this display, press the
shown.
+
2. Press the
Up or
If you have questions about installation, programming, operating and routine maintenance...
call 1- - 866- - 986- - 3223, Monday - - Friday, 8 am to 9 pm, EST.
PROGRAM button until the following screen is displayed.
PROGRAM button four times and following display is shown.
−
Down buttons to set number of days.
PROGRAM button until the following screen is displayed.
PROGRAM button five times and the following display is
12 Hour Clock Initiated
−
Down buttons to set clock.
24 Hour Clock Initiated