Selecting the Remote Controller Custom Code
Use the following steps to select the custom code of the remote controller.
( Note that the air conditioner cannot receive a custom code if the
air conditioner has not been set for the custom code.)
(1) Press the START/STOP (
on the remote controller display.
(2) Press the MODE button for at least 5 seconds to display the current
custom code (initially set to
(3) Press the SET TEMP. (
custom code between
Match the code on the display to the air conditioner custom code.
(4) Press the MODE button again to return to the clock display.
The custom code will be changed.
If no buttons are pressed within 30 seconds after the custom code is displayed,
the system returns to the original clock display. In this case, start again from step 1.
The air conditioner custom code is set to A prior to shipment.
) button until only the clock is displayed
).
/
) buttons to change the
.
03-05