Selecting The Remote Controller Custom Code - Fujitsu GENERAL ASWG18JFCB Operating Manual

CLEANING AND CARE
Filter Indicator Reset (The special setting)
• Can be used if set correctly during installation.
Please consult authorized serviceman when using this function.
• It lights on when it is time to clean the air fi lters.
Clean the fi lter referring to "CLEANING AND CARE".
After cleaning, press the MANUAL AUTO button (Fig. 2 2 ) for 2 seconds or less on
the indoor unit.

SELECTING THE REMOTE CONTROLLER CUSTOM CODE

When two or more air conditioners are installed in a room and the Remote Controller is operating an air conditioner other than the
one you wish to set, change the custom code of the Remote Controller to operate only the air conditioner you wish to set (4 selec-
tions possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner custom
codes.
Selecting the Remote Controller Custom Code
Use the following steps to select the custom code of the Remote Controller. (Note that
the air conditioner cannot receive a custom code if the air conditioner has not been set
for the custom code.)
1
Press the START/STOP button until only the clock is
displayed on the Remote Controller display.
2
Press the MODE button for at least five seconds to
display the current custom code (initially set to ).
3
Press the (
between
to the air conditioner custom code.
4
Press the MODE button again to return to the clock
display. The custom code will be changed.
● If no buttons are pressed within 30 seconds after the custom code is displayed, the system returns to the original clock display. In this case,
start again from step 1.
● The air conditioner custom code is set to A prior to shipment. Contact your retailer to change the custom code.
● The Remote Controller resets to custom code A when the batteries in the Remote Controller are replaced. If you use a custom code other than
custom code A, reset the custom code after replacing the batteries.
If you do not know the air conditioner custom code setting, try each of the custom codes (
the air conditioner.
/ ) buttons to change the custom code
. Match the code on the display
● Indicator Lamp
OPERATION
TIMER
ECONOMY
: Flashing : OFF
) until you fi nd the code which operates
En-14